Reset the router to factory default settings
Digi TransPort User Guide 798
Reset the router to factory default settings
The Administration > Factory Default Settings page resets the router’s configuration back to
the factory defaults. You must reboot the router before the configuration changes take effect.
Keep network settings
Selecting this option preserves certain network settings does not revert them back to the
factory defaults. The network settings that are preserved are:
• Ethernet 0 IP address
• Ethernet 0 Mask
• Ethernet 0 Gateway
• Ethernet 0 DHCP Client
• Ethernet 0 DNS Server
• Default Route 0 Interface
• PPP 1 Username
• PPP 1 Password
• PPP 3 Username
• PPP 3 Password
• Mobile APN
• Mobile SIM PIN
Restore
Initiates a factory reset of the router.
Related CLI commands
To reset the router’s configuration to the factory defaults, use the following commands:
del pwds.da0
copy config.fac config.da0
These commands assume you are using configuration profile 0. If you are using configuration
profile 1, use the suffix .da1 instead.
Using these commands does not preserve any network settings.
To Next Page
Loading...
