Digi TransPort - Modbus Slaves Parameters

Configure MODBUS Gateway parameters
Digi TransPort User Guide 566
MODBUS Slaves parameters
This page defines access for the following MODBUS slaves when operating as act-as-slave. Up to
32 slave definitions may be defined.
Slave addresses/unit ids
The address of the slave unit.
Remote Host
The IP address of the remote host, such as the slave unit.
IP Port
The IP port number. The default port is 502.
IP Mode
Select the IP mode using this drop down list. The default mode is TCP.
Add
Click on the add button to add the slave.