Digi TransPort - Configure IP Routing and Forwarding

Digi TransPort User Guide 348
Configure IP routing and forwarding
This section covers configuring IP routing and forwarding from the web interface and command
line. It covers the following topics:
• View the TransPort routing table on page 349
• Supported routes on page 349
• IP Routing parameters on page 352
• Static routes on page 355
• Default Route n parameters on page 361
• RIP parameters on page 368
• Interfaces > Ethernet / PPP / GRE parameters on page 373
• BGP parameters on page 377
• IP Port Forwarding / Static NAT Mappings parameters on page 379
• IP Port Forwarding / Static NAT Mappings parameters on page 379
• Multicast Routes parameters on page 381
• Virtual Routing and Forwarding (VRF) on page 383