Configure serial interfaces
Digi TransPort User Guide 285
MultiTX parameters
The MultiTX page is for enabling and setting the MultiTX parameters. This page supports sending
serial data to multiple (up to 5) TCP or UDP destinations. When enabled, the configured ASY port
is opened and serial data from the port is sent to all configured destinations.
Enable Multitx
When enabled, displays the MultiTX settings in the GUI and enables the MultiTX function on
the router.
Serial Port
The serial interface to use. Data received on this serial will be forwarded to all configured
remote hosts.
Protocol
Whether TCP or UDP will be used as the transport method.
Socket Inactivity Timeout
If there is no data transmitted for the specified number of seconds, the socket will be closed.
0=no timeout.
Send Socket ID
When enabled, the text entered into the Socket ID field is transmitted to the remote host
when the socket connects.
Reopen Closed Socket
Enables an always-on mode. If the socket is closed for any reason, the router attempts to
reconnect to the remote host.
Socket ID
Used in conjunction with Send Socket ID. The text entered is transmitted when the socket
connects. \r can be used for CR. \n can be used for NL. Hex can be specified by using \xhh
where hh is replaced with the hex code, such as \x04 will define binary character 04.
To Next Page
Loading...
