Configure Dynamic DNS
Digi TransPort User Guide 347
Advanced Dynamic DNS parameters
The parameters in this section do not normally need changing from their defaults.
Note Before configuring dynamic DNS or any of these parameters, it is recommended that you
view the information and resources available at the website http://dyn.com.
Update interval d days
The number of days between dynamic DNS updates.
Supply the IP address in the update
When enabled (the default), causes the router to supply the IP address as part of the dynamic
DNS update. When unchecked, the IP address is not supplied and the DYNDNS server
attempts to determine the correct IP address by other means (IP source address in update
packet). This mode would normally only be used if the router is behind a NAT router.
Only send update when this router is the VRRP master
When enabled, causes the router to not send DDNS updates unless at least one Ethernet
interface is a VRRP master.
Enable debug
When enabled, enables debug tracing of the dynamic DNS transactions.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
dyndns 0 updateint 0 -255 Update interval d days
dyndns 0 noip OFF,ON Supply the IP address in the update
dyndns 0 ifvrrpmaster OFF,ON Only send update when this router
is the VRRP master
dyndns 0 debug OFF,ON Enable debug
To Next Page
Loading...
