Application commands
Digi TransPort User Guide 137
Application commands
The TransPort device also supports numerous text-based application commands that are specific
to Digi International products, and do not require the AT prefix. Some of these are generic, such
as they are related to the general operation of the router; others are application- or protocol-
specific.
This section contains the following information about application commands:
• Lock the interface speed to the terminal on page 138
• Application commands are case-insensitive on page 138
• One command per line on page 138
• Application command syntax on page 138
• Using wildcards on page 139
• Using the CLI parameter tables in this guide on page 140
• reboot command: reboot router on page 141
• config command: show/save configuration on page 142
• ping command: Troubleshoot connectivity problems on page 143
• traceroute command: Troubleshoot connectivity problems on page 143
• ana command: Clear the Analyser Trace on page 143
• clear command: Clear the Event Log on page 143
• Activate and deactivate interfaces on page 144
• gpio command: General Purpose Input Output (GPIO) on page 145
• qdl command: Select cellular image to load on page 147
• tcpperm command: establish a permanent serial to IP connection on page 148
• tcpdial command: Establish a manually initiated serial to IP connection on page 150
• tcpdab command: Cancel a tcpdial connection on page 150
To Next Page
Loading...
