Digi TransPort User Guide 488
Configure time bands
This section covers configuring time bands from the web interface or command line. It covers the
following topics:
• About time bands on page 488
• Enable and disable time bands for a PPP instance on page 489
• Timeband page parameters on page 490
• Related CLI commands on page 491
About time bands
Digi TransPort routers support time bands. Time bands are used to determine periods of time
during which PPP interfaces allowed or prevented from activating. For example, a router in an
office could be configured so that the ADSL PPP interface is only raised on weekdays.
Time bands can only be applied to PPP instances.
Time bands are specified by a series of transition times. At each of these times, routing is either
enabled or disabled. The default state for a time band is On, which means that PPP instances that
are associated with unconfigured time bands will operate normally.
The router supports four time band configurations.
Whenever a time band transition occurs, an entry is made in the event log.
To Next Page
Loading...
