Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort User Guide 500
Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort routers can send Systems Network Architecture (SNA) traffic over TCP/IP, using the
DLSw protocol, often called SNAIP. They can also can send HDLC traffic over TCP/IP.
About SNA
SNA uses Synchronous Data Link Control (SDLC), an unbalanced mode in which there is one
master station and one or more secondary stations. Each secondary station owns a station
address and can only respond when this address has just been polled by the master. A typical
scenario is shown in the diagram below:
To Next Page
Loading...
