Event Settings parameters
Digi TransPort User Guide 600
Syslog Server n parameters
This section describes the configuration of the router for defining the Syslog server to send
messages to.
Syslog server IP address
The IP address of the server.
Port
The port to use.
Note The following three items (Mode, TCP timeout, and Route) only appear on routers that
have the TCP logging software option enabled. This is not a commonly used option.
Mode
There are currently three supported communication modes; these are selected from a drop-
down list and are TCP, UDP, and a protocol described in RFC 3195.
TCP timeout s seconds
For TCP communications, this parameter sets the timeout on the socket.
Route using
These radio buttons select which method of establishing a route to the server to use.
Routing table
When this radio button is selected, the routing table is used to determine the interface that
will be used to transmit the syslog message.
Interface x,y
If the routing table is not to be used, an interface type (PPP or Ethernet) can be selected from
the drop-down selection box, and the interface instance number can be typed into the
adjoining text entry box. The route is then determined by that interface.
Priority
The checkboxes listed in this section select the event priorities that should cause the event to
be logged.
To Next Page
Loading...
