Digi TransPort - Execute a Command

Execute a command
Digi TransPort User Guide 799
Reset the router using the hardware reset button
• Most routers have a reset button on the underside of the router.
• To perform a factory reset on the router, press and hold the reset button for 5 seconds.
• When the reset is initiated in this manner, the LEDs on the front of the router flash to indicate
a reset is in progress.
• The router automatically reboots once the factory reset is complete. Do not remove the
power while the router is running this reset procedure.
• Using this method will not preserve any settings.
• To disable the reset button, enter:
cmd 0 pbreset off
• To re-enable the reset button functionality, enter:
cmd 0 pbreset on
Execute a command
• The Administration > Execute a Command page allows CLI commands to be entered via
the web browser.
• Almost all of the CLI commands detailed in this reference guide can be entered from this page.
• Enter the command name and click the Execute button.
• The command output is displayed, as shown in the following example.