Digi TransPort - General System Parameters

General system parameters
Digi TransPort User Guide 621
General system parameters
The General system parameters page has the following settings.
Autorun Commands
The router can be configured to run a number of commands once it has booted. These
commands are associated with specific asynchronous serial interfaces. For example, suppose a
Script Basic script, sample.bas, must be run at boot up. Autorun commands are normally
associated with an ASY port, but running a script for example is not ASY port-specific.
To configure the autorun commands, set the following values:
#
The command interface to be associated with the command. In the above example, this would
be set to the number 0.
Command
The CLI command to run on start-up. In the above example, this field would be set to the
string bas sample.bas.
Related CLI commands.
Entity Instance Parameter Values Equivalent Web Parameter
cmd n autocmd Valid CLI command Autorun Commands