Digi TransPort - Page 620

Date and Time parameters
Digi TransPort User Guide 620
ntpstat command: Check NTP client status
To check the status of the NTP client, use the ntpstat command.
View NTP system status information
ntpstat sys
View NTP peer information
ntpstat peers
Reset system information and allow NTP to recalculate the drift compensation
ntpstat rst
ntp n maxpoll2 3-14 Poll Interval s1, s2
See minpoll for values
ntp n burstint2 0-255 Startup burst Interval s
seconds
ntp n server3 Valid IP address or
hostname, such as
ntp3.timeserver.org
NTP Server.
ntp n bcast3 0,1 Broadcast Mode
0=disabled
1=enabled
ntp n minpoll 3-14 Poll Interval s1, s2
See minpoll for values
ntp n maxpoll 3-14 Poll Interval s1, s2
See minpoll for values
ntp n burstint3 0-255 Startup burst Interval s
seconds
ntp n server4 Valid IP address or
hostname, such as
ntp4.timeserver.org
NTP Server.
ntp n bcast4 0,1 Broadcast Mode
0=disabled
1=enabled
ntp n minpoll4 3-14 Poll Interval s1, s2
See minpoll for values
ntp n maxpoll4 3-14 Poll Interval s1, s2
See minpoll for values
ntp n burstint4 0-255 Startup burst Interval s
seconds