SNMP parameters
Digi TransPort User Guide 635
SNMP parameters
The Simple Network Management Protocol (SNMP) is a well-established way of managing
clusters of remote routers. The TransPort routers support versions 1, 2c, and 3 of this protocol.
Supported Management Information Bases (MIBs)
The standard Management Information Bases (MIBs) supported by the router are detailed below.
Besides these, there are two other MIBs that are supplied as standard.
• There is a MIB that is generated after the firmware has been installed. This is accomplished
using the mibprint CLI command and the MIBEXE DOS tool, available from the Technical
Support Team. This MIB changes with every firmware release, since the firmware revision is
embedded in the Object Identifiers (OIDs). This MIB provides access to most of the
configuration and statistics that are associated with the router.
• The second MIB is the Monitor MIB, which is a standard MIB that gives access to various Digi
TransPort proprietary objects. The OIDs in this MIB do not change with every release, although
it is possible for new objects to be added to it. This MIB is available from the Technical Support
team.
The standard MIBs supported are:
• SNMP MIB (RFC3418)
• Interfaces MIB (RFC2233)*
• IP MIB (RFC2011)
• IP Forwarding Table MIB (RFC2096)
• TCP MIB (RFC2012)
• UDP MIB (RFC2013)
• VRRP MIB (RFC2787)
• SNMP MPD MIB (RFC3412)
• SNMP USM MIB (RFC3414)**
* The following groups/tables in RFC2233 are not supported: ifXTable, ifStackTable,
ifRcvAddressTable.
** The following groups/tables in RFC3414 are not supported: usmUserTable.
Other MIBs may be available on request.
To Next Page
Loading...
