Digi TransPort - Page 167

Configure Ethernet interfaces
Digi TransPort User Guide 167
Related CLI Commands
Entity Instance Parameter Values Equivalent Web Parameter
eth n vrrpid 0-255 VRRP Group ID
eth n vrrpprio 0-255 VRRP Priority
eth n vboostprio 0-255 Boost the priority by n for s
seconds after switching to the
MASTER state
eth n vboostsecs Integer Boost the priority by n for s
seconds after switching to the
MASTER state
eth n vprobemode off, TCP,
ICMP
Send p probe to IP address a.b.c.d
TCP port n
eth n vprobeip IP Address Send p probe to IP address a.b.c.d
TCP port n
eth n vprobeport 0-65535 Send p probe to IP address a.b.c.d
TCP port n
eth n vprobebackint 0-32767 every n seconds when in Backup
state
eth n vprobemastint 0-32767 every n seconds when in Master
state
eth n vprobeadj 0-255 Adjust priority n dir after x probe
failures
eth n vprobeadjup 0=down
1=up
Adjust priority n dir after x probe
failures
eth n vprobefailcnt 0-255 Adjust priority n dir after x probe
failures
eth n vprobesuccesscnt 0-255 Reset probe failure count after n
probe successes
eth n vprobeent Auto, ETH,
PPP
Use interface x,y over which to
send probe
eth n vprobeadd Integer Use interface x,y over which to
send probe
eth n vprobeipent Auto, ETH,
PPP
Get the source IP address from
interface x,y
eth n vprobeipadd Integer Get the source IP address from
interface x,y