TransPort WR11 hardware
Digi TransPort User Guide 21
TransPort WR11 HSPA+ model hardware features
1. LAN port: This Ethernet port connects the device to a 10/100 base-T Local Area Network
(LAN). The port is capable of auto-sensing for speed and wiring, so it can accept both straight-
through or cross-over cable connections.
2. Power cord input: This locking power connector connects the device to a power source. The
connector should be inserted and rotated to lock in place.
3. LEDs:
• SERVICE LED: Indicates the presence and level of cellular service running on the device.
Off: No cellular service
1 Blink: GPRS mode
2 Blinks: EDGE mode
3 Blinks: UMTS mode
4 Blinks: HSDPA mode
5 Blinks: HSUPA mode
• SIGNAL LED: Indicates strength of cellular signal.
Off: Poor or No signal. Place the device in a location where it gets a better signal.
Amber: Fair
Green: Good
• POWER LED:
Off: No power
Green: TransPort device is powered
To Next Page
Loading...
