Configure ISDN interfaces
Digi TransPort User Guide 233
Stop data from being transmitted after n units
The total amount of data that may be transmitted by this PPP instance before the link is
blocked for further traffic, and the value in the drop-down list specifies the units which are
kilobytes, megabytes, gigabytes.
Reset the data limit on the n day of the month
The value in this text box specifies the day of the month on which the data limit is reset to
zero.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
ppp n metric 0-255 Metric
ppp n aodion 0-2
0=disabled
1=enabled
2=On and
return to service
immediately
Enable “Always On” mode of this
interface, On, On and return to
service immediately
ppp n immoos ON, OFF Put this interface “Out of Service”
when an always-on connection
attempt fails
ppp n aodi_dly 0-2147483647 Attempt to reconnect after s
seconds
ppp n aodi_dly2 0-2147483647 If an inhibited PPP interface is
connected, attempt to re-connect
after s seconds
ppp n pwr_dly 0-2147483647 Wait s seconds after power-up
before activating this interface
ppp n tband 0-4 Control when this interface can
connect using Time Band n
ppp n minup 0-2147483647 Keep this interface up for at least s
seconds
ppp n maxup 0-2147483647 Close this interface after s seconds
ppp n maxuptime 0-2147483647 if it has been up for m minutes in a
day
ppp n timeout 0-2147483648 if the link has been idle for s
seconds
ppp n timeout2 0-2147483648 Alternative idle timer for static
routes s seconds
ppp n rxtimeout 0-2147483648 if the link has not received any
packets for s seconds
To Next Page
Loading...
