Digi TransPort - Page 252

Configure PSTN interfaces
Digi TransPort User Guide 252
Keep Security Associations (SAs) when this PSTN interface is disconnected
When enabled, causes the router to maintain (such as not flush) the SA when the interface
becomes disconnected. The normal behavior is to remove the SAs when the interface
becomes disconnected.
Use interface x,y for the source IP address of IPsec packets
If it is required to use another interface (such as not the interface currently being configured)
as the source address for IPsec packets, this may be achieved by selecting the desired
interface from the drop-down list and typing the desired interface instance number into the
adjacent text box.
Enable the firewall on this interface
When enabled, applies the firewall rules to traffic using this interface.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
ppp n name Up to 25
characters
Description
ppp n phonenum up to 25 digits Dial out using numbers
ppp n ph2 “ “
ppp n ph3 “ “
ppp n ph4 “ “
ppp n prefix 0-9999999999 Prefix n to the dial out number
ppp n username Up to 60
characters
Username
ppp n password Up to 40
characters
Password
ppp n IPaddr 0.0.0.0 Allow the remote device to assign a
local IP address to this router
ppp n IPaddr Valid IP address
a.b.c.d
Try to negotiate a.b.c.d as the local
IP address for this router
(in conjunction with l_addr)
ppp n l_addr OFF,ON
When ON,
allows
negotiation
when OFF force
use of specified
IP address
Use a.b.c.d as the local IP address of
this router
ppp n DNSserver Valid IP address
a.b.c.d
Use the following DNS servers if not
negotiated
Primary DNS server a.b.c.d