Configure serial interfaces
Digi TransPort User Guide 283
Enable RealPort
Enables RealPort on the router.
Listen on port
The TCP port on which the router will listen for RealPort connections.
Maximum number of sockets
The maximum number of RealPort connections that the router will support.
Enable encrypted RealPort
Selecting this option enables encrypted RealPort on the router.
Encryption mode to listen on port
The TCP port on which the router will listen for encrypted RealPort connections.
Maximum number of encryption sockets
The maximum number of encrypted RealPort connections that the router will support.
Enable Device Initiated RealPort
Selecting this option enables router to make a RealPort connection to a host PC.
Connect to host a.b.c.d Port n
The IP address or hostname and TCP port that the router should use when making a device
initiated connection.
Allow s seconds between connection attempts
The interval, in seconds, between device initiated connection attempts.
Send TCP Keep-Alives every s seconds
The interval at which TCP Keep-Alives are sent over the RealPort connection. A value of 0
means that Keep-Alives are not sent.
Send RealPort Keep-Alives every s seconds
The interval at which RealPort Keep-Alives are sent over the RealPort connection. A value of 0
means that Keep-Alives are not sent.
Enable exclusive mode
Enables exclusive mode. Exclusive mode allows a single connection from any one RealPort
client ID to be connected only. If this setting is enabled and a subsequent connection occurs
that has the same source IP as an existing connection, the old existing connection is forcibly
reset under the assumption that it is stale.
Enable authentication
Enables RealPort authentication.
Authentication secret
Configures the RealPort authentication secret.
To Next Page
Loading...
