Digi TransPort - Page 292

Configure Advanced interfaces settings
Digi TransPort User Guide 292
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
mlppp 0 l_accm 0x00000000-
0xFFFFFFFF
Desired local ACCM
mlppp 0 r_accm 0x00000000-
0xFFFFFFFF
Desired remote ACCM
mlppp 0 username Valid username username
mlppp 0 password Valid password password
mlppp 0 epassword Encrypted
password
None-this parameter is not
configurable
mlppp 0 r_chap ON, OFF Enable remote CHAP authentication
mlppp 0 l_shortseq ON, OFF
Default OFF
Enable short sequence numbers
mlppp 0 up_rate 0-2147483648
Default 2000
When the data rate is greater than n
bytes/sec
mlppp 0 up_delay 0-2147483648
Default 10
for s seconds
mlppp 0 down_rate 0-2147483648
Default 1000
When data rate is less than n bytes/
sec
mlppp 0 down_delay 0-2147483648
Default 10
for s seconds
mlppp 0 dup_rate 0-2147483648
Default 500
When data rate is greater than n
bytes/sec
mlppp 0 dup_delay 0-2147483648
Default 5
for s seconds
mlppp 0 ddown_rate 0-2147483648
Default 500
When data rate is less than n bytes/
sec
mlppp 0 ddown_delay 0-2147483648
Default 5
for s seconds