Configure Advanced interfaces settings
Digi TransPort User Guide 304
Wait s seconds after power-up before activating this interface
The initial delay the router applies before activating the PPP instance after power-up. After the
initial power-up delay the normal always-on activation timers apply. If set to zero, no delay will
be applied.
Keep this interface up for at least s seconds
The minimum period that the PPP interface should remain available. This means that even if
the link becomes inactive before this period expires, the connection will remain open.
Enable Multilink PPP on this interface
When enabled, enables the multilink PPP capability of the router. (See above for configuration
details).
Click here to assign a timeband to this interface
Clicking this link redirects the browser to the timeband configuration page Configuration >
Network > Timebands.
Add a route to a.b.c.d if the peer’s IP address is not negotiated
Normally, the IP address for a device connecting to a remote peer is assigned by the remote
peer. If this is not the case then the router will need a route to the remote peer. This setting is
set to the IP address of the remote peer so that it can be added to the routing table.
Forward IP broadcasts over this interface if the interface is on the same IP network as an
Ethernet interface
When enabled, causes the router to route broadcast packets to and from Ethernet interfaces.
This will only occur if the PPP instance has issued an address which is part of the Ethernet
interface network.
To Next Page
Loading...
