Static routes
Digi TransPort User Guide 359
When this route becomes unavailable, remove the “Out of Service” state on x,y
This drop-down list and text box are used to specify the interface (available options are None,
PPP, Ethernet and Tunnel) and instance that should be taken out of the Out of Service state
when the interface that this route is configured to use is deactivated.
Keep this route in service for s seconds after OOS state is cleared
When enabled, the following text box is enabled (such as it is no longer disabled), allowing a
value to be entered. The value specifies the period that the interface specified above will
remain in service even though it is actually unable to pass traffic immediately. This is behavior
useful in situations where a PPP interface is activating and traffic should not try the next
interface until this one has been allowed a certain amount of time to come up. When this
timer expires, if the interface is unable to pass traffic, it will be marked Out of Service and the
next interface will be tried.
Assign this route to recovery group n
Assigns the route to a recovery group. This means that if all the routes in a particular recovery
group go out of service, the out of service status is cleared for all routes in that group. If one
route in a group comes back into service, all routes with a lower priority (metric) also have
their out of service status cleared.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
route n metric 0-2147483647 Use metric n when the interface is
not active
route n srcip Valid IP address
a.b.c.d
IP Address a.b.c.d
route n srcmask Valid netmask
a.b.c.d
Mask a.b.c.d
route n inrip on,off Include this route in RIP
advertisements
route n doinact2 on,off Make PPP n interface use the
alternative idle timeout when this
route becomes available
route n inact2add 0-2147483647 Make PPP n interface use the
alternative idle timeout when this
route becomes available
route n pwr_dly 0-255 Wait for s seconds after power up
before allowing this route to
activate the interface
To Next Page
Loading...
