RIP parameters
Digi TransPort User Guide 370
Access Lists parameters
The router has the ability to modify route metrics based upon received RIP responses. Static
routes and default routes will have their metric modified if the route fits within one of the routes
found within the RIP packet. For Ethernet routes, the gateway for the route will be set to the
source address of the RIP packet. The route modifications will be enforced for 180 seconds,
unless another RIP response is received within that time.
RIP packets must have a source address that is included in the RIP access list.
Adding permitted IP addresses to the access list is controlled using a table with the single
parameter described below.
IP Address a.b.c.d
The IP address to be added to the list of IP addresses that RIP packets must come from if they
are to modify route metrics. Up to ten IP addresses may be added. The Add and Delete
buttons work in the usual way for configuration tables.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
riprx 0-9 IPaddr Valid IP address
a.b.c.d
IP Address a.b.c.d
To Next Page
Loading...
