Digi TransPort - Page 376

OSPF parameters
Digi TransPort User Guide 376
Restart OSPF after configuration file is saved
When enabled, restarts the OSPF functions once the edited configuration file has been saved.
Restart OSPF if a fatal error occurs
When enabled, restarts OSPF functioning after a delay of 5 seconds if a fatal error occurs.
OSPF Tracing
In common with some of the other functionality of the router, OSPF supports some debug
functionality. The amount of information in the debug traces is controlled from this drop-
down list. The available levels are Off, Low, Med, and High. Selecting Off disables debug
tracing.
Ignore MTU indications
All OSPF routers must have the same Maximum Transmitted Unit (MTU) and this value is
advertised in the OSPF packets. When checked, the router ignores received packets that have
a MTU that differs from that of the router itself.
Use Interface IPsec source IP
When enabled, OSPF functions use the source IP address of the interface specified in
Configuration > Network > Interfaces > Advanced > PPP n: Use interface x,y for the
source IP address of IPsec packets on the interface being used. When unchecked, OSPF
uses the source IP address of the interface being used for its source address.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
ospf 0 Enable on,off Enable OSPF
ospf 0 conffile OSPF Configuration Filename
ospf 0 new_cfg_rest on,off Restart OSPF after a
configuration file is saved
ospf 0 fatal_rest on,off Restart OSPF if a fatal error
occurs
ospf 0 debug 0-3
0=Off
1=Low
2=Med
3=High
OSPF Tracing
ospf 0 ignore_mtu on,off Ignore MTU indications
ospf 0 useipsecent on,off Use Interface IPsec source IP