BGP parameters
Digi TransPort User Guide 378
Advertise non-connected networks
When enabled, BGP advertises networks that exist in the BGP configuration file but that are
not actually a connected network or interface.
BGP Tracing
As with OSPF, the level of debug tracing information is selected from this drop-down list. The
available levels are; Off, Low, Med, and High.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
bgp 0 enable on,off Enable BGP
bgp 0 conffile BGP Configuration Filename
bgp 0 new_cfg_rest on,off Restart BGP after configuration
file is saved
bgp 0 fatal_rest on,off Restart BGP if a fatal error
occurs
bgp 0 allow_non_nets on,off
Default ON
Advertise non-connected
networks
bgp 0 debug 0-3 BGP Tracing
To Next Page
Loading...
