Digi TransPort - Page 518

Configure TPAD parameters
Digi TransPort User Guide 518
If the terminal dial command specifies V.120 use PANS context x
This parameter is for advanced users only. It enables TPAD transactions to be carried out
using the V.120 protocol (ATDV command). The parameter is used in conjunction with the
Polling Answering Service (PANS), and identifies which PANS instance is to be used for an
outgoing V.120 call. For this to work, the PANS instance must be bound to a Rate Adaption
instance.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
tpad n l2iface lapb, lapd, tcp, ssl, vxn Use TPAD over interface.
tpad n l2nb 0-255 Use TPAD over interface.
tpad n ipmode 0=XOT, 1=raw TCP Use TPAD over interface.
tpad n bakl2iface lapb, lapd, tcp, ssl, vxn Use backup interface.
tpad n bakl2nb 0-255 Use backup interface.
tpad n bnumber text (valid ISDN number) Use number x to make outgoing
ISDN calls.
tpad n prefix text (numeric) Use prefix x
tpad n prefix_rem text (numeric) Remove prefix x from number in
ATD command.
tpad n suffix text (numeric) Use suffix x.
tpad n tl2deact 0-10000 On the main interface Deactivate
LAPB session x seconds after TPAD
X.25 call has been cleared.
tpad n baktl2deact 0-10000 On the backup interface
Deactivate LAPB session x seconds
after TPAD X.25 call has been
cleared.
tpad n defpak 16,32,64,128,256,512,1024 Default X.25 Packet Size.
tpad n nua text Use NUA.
tpad n nui text Use NUI.
tpad n lcn 1-4095 LCN.
tpad n lcnup 1=up, 0=down LCN direction.
tpad n baknua text (Backup) Use NUA.
tpad n baknui numeric text (Backup) Use NUI.
tpad n baklcn 1-4095 (Backup) LCN.
tpad n baklcnup 1=up, 0=down (Backup) LCN direction