Digi TransPort - Page 520

Configure TPAD parameters
Digi TransPort User Guide 520
tpad n teretran 1=enabled, 0=disabled Retransmit APACS 30 string if error
detected.
tpad n delstx 1=enabled, 0=disabled STX/ETX removal.
tpad n no_enq 1=enabled, 0=disabled Do not transmit ENQ characters.
tpad n tenqdel 0-5000 Delay sending ENQ characters to
TPAD terminal for x milliseconds
when a call has been connected.
tpad n tackdel 0-10000 Wait for x milliseconds for an ACK
before retransmitting the data.
tpad n dsync 1=enabled, 0=disabled Transmit TPAD transactions
directly in a Synchronous frame.
tpad n inclrc 1=enabled, 0=disabled Include LRC.
tpad n incllrc 1=enabled, 0=disabled Include LRC line.
tpad n fpar 1=enabled, 0=disabled Force parity when sending data to
the terminal.
tpad n lrpar 1=enabled, 0=disabled Strip parity when sending data to
the host.
tpad n lfpar 1=enabled, 0=disabled Force parity when sending data to
the host.
tpad n strip_tspaces 1=enabled, 0=disabled Strip Trailing Spaces.
tpad n ackdat 1=enabled, 0=disabled Acknowledge TPAD data packets.
tpad n stx_2_soh 1=enabled, 0=disabled Convert leading STX character to
SOH.
tpad n eot_only 1=enabled, 0=disabled Terminate TPAD call is EOT only.
tpad n tresp 0–1000 Clear TPAD call if there is no
response to a TPAD transaction
request for x seconds.
tpad n texcess 0–100 Generate an event when a TPAD
transaction takes longer than x
seconds
tpad n tsla 0–3000 When the transaction time
exceeds x milliseconds, increment
the SLA Exceptions statistic.
tpad n clear_time 0-2147483647 Clear the call x seconds after
receiving a response
tpad n dialctx 0-255 If the terminal dial command
specifies V.120 use PANS context x.
Entity Instance Parameter Values Equivalent Web Parameter