Digi TransPort - Page 526

Configure X.25 parameters
Digi TransPort User Guide 526
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
lapb n l1iface port, isdn (use “port”
for sync port)
Use: Serial port Port x (in Synchronous Mode)
lapb n l1nb 0,1 Use: Serial port Port x (in Synchronous Mode)
0 for Port 0, 1 for Port 1
lapb n l1iface port, isdn (use “isdn”
for ISDN)
Use: ISDN
lapb n dtemode DTE/DCE mode:
0=DTE
1=DCE
Mode DTE or DCE
lapb n N400 1-255 N400 Counter x
lapb n tnoact 1000-60000 RR Timer x milliseconds
lapb n t1time 1-60000 T1 Timer x milliseconds
lapb n t200 1-60000 T200 Timer x milliseconds
lapb n Window 1-7 X.25 Window Size
lapb n tinactx25 0-3000 Disconnect link if there has been no X.25
activity for x seconds
lapb n tinact 0-3000 Disconnect link if there has been no activity for
x seconds
lapb n restartact 1=enabled,
0=disabled
Send X.25 Restart packet on receipt of SABM
frame
lapb n ans 1=enabled,
0=disabled
Allow this unit to answer calls
lapb n msn text Only accept calls from calling number ending
with
lapb n sub text Only accept calls with sub-address ending with
lapb n ptime 0-60000 Wait x milliseconds before attempting to
establish the LAPB link after B-channel
becoming active
lapb n cli text Only answer calls from numbers whose
trailing digits match
lapb n mux_0710 1=enabled,
0=disabled
Mux 0710 mode
lapb n mux_mode 0=Basic, 1=Error
Recovery
Mux mode