Digi TransPort - Page 623

General system parameters
Digi TransPort User Guide 623
CLI Post-Login Banner
Once the user has successfully logged on to the router, a second message can be displayed.
This parameter specifies the name of a file containing the text to display. As above, the file
may contain site-specific instructions to be carried out once the user has logged in.
Allow CLI access from X.25 address n
Enables/disables logging into the router over an X.25 connection. The parameter n must be a
valid X.25 NUA (Network User Address).
With TRANSIP, use access level None, Low, Med, High, Super
Controls the security access level when using TRANSIP to access the router.
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
cmd n tremto 0-86400 seconds Automatically log user out if idle
for h hrs m mins s seconds
This CLI value is entered in
seconds only.
local n access 0-4 Use access level
0=Super
1=High
2=Medium
3=Low
4=None
8=Read only
local n tlocto Free text field Never, h hrs, m mins, s secs
cmd n noremecho 0,1 Enable Remote command echo
0=Off (default)
1=On
cmd n prebanner Valid filename such
as
welcome1.txt
CLI Pre-Login Banner
cmd n postbanner Valid filename such
as
welcome2.txt
CLI Post-Login Banner
cmd n cmdnua 0-1023 Allow CLI access from X.25
address
local n transaccess 0-4 With TRANSIP, use access level
0=Super
1=High
2=Medium
3=Low
4=None
8=Read only