Firewall configuration
Digi TransPort User Guide 652
Edit
These buttons that appear to the right of the rule open up the rule in an edit text box which
allows the text to be edited. Click on the OK button to commit the changes or Cancel to
abandon the edit.
Reset Hit Counters
Clicking this button resets to zero all the rule hit counts that appear in the left-hand column of
the table.
Save
Clicking this button saves changes to the table to the fw.txt file. If the changes are not saved
using this button, they will be lost if the router is rebooted or loses power.
Restore
If, after reviewing changes to the table it is decided that the edit should be abandoned, clicking
this button restores the original fw.txt to the table, provided that they have not been saved.
Below the firewall editor table is another table that controls the interfaces to which the
firewall rules apply.
Interface
A list of the available interfaces to which the firewall rules may be applied.
Enabled
Check the checkbox next to the interface(s) that the firewall should operate on to enable the
firewall for that interface.
Related CLI commands
The firewall rule hits may be viewed from the command line console by using the command:
type fwstat.hit
Entity Instance Parameter Values Equivalent Web Parameter
fw n/a logclr - Reset Hit Counters
fw n/a save - Save
fw n/a - - Restore
To Next Page
Loading...
