Manage files
Digi TransPort User Guide 779
TYPE command: Display a text file
The type command displays the contents of a text file. The format is:
type <filename>
For example:
type config.da0
[CFG]
config last_saved "12:04:45, 31 Jan 2011"
config last_saved_changes "1"
config last_saved_user "ASY 0"
eth 0 descr "LAN 0"
eth 0 IPaddr "10.1.51.3"
eth 0 mask "255.255.0.0"
eth 0 bridge ON
eth 1 descr "LAN 1"
eth 2 descr "LAN 2"
eth 3 descr "LAN 3"
eth 4 descr "ATM PVC 0"
XMODEM command: Initiate an XMODEM file upload
The xmodem command initiates an XMODEM file upload from the port at which the command is
entered. The format is:
xmodem <filename>
<filename>
The name under which the file will be saved when the upload is complete.
After the xmodem command is entered, the router waits for your terminal program to start
transmitting the file. When the upload is complete and the file has been saved, the router
responds with the OK result code.
To initiate a remote XMODEM upload, establish a Telnet session over ISDN, and then issue the
xmodem command from the remote terminal.
To Next Page
Loading...
