Control|24 Guide138
Group Test Mode
Group test mode places the faders on Control|24
in a test mode where the faders become grouped
and can be moved, lock-step, to indicate that all
faders are operating properly in a grouped fash-
ion.
When “Grp” Fader Test Mode is Engaged:
• The encoder switch LED located below the
scribble strip which shows “Grp” will light
solid indicating that this is the chosen test
mode.
• All other display test menu items shown on
the scribble strips as well as their associated
flashing encoder switch LEDs, will remain vis-
ible in this test mode. The scribble strip dis-
plays will toggle back and forth between the
group cycle values, which allows you to select
another display test mode without the need
to first “Exit” this mode.
•Touch any fader and move the fader to any
position on the fader path. All other faders
will move, lock-step, to the position of the
master.
• The fader position value will be shown in
these scribble strips and will be updated in
real-time as the faders are moved in group
mode. Values will range from off (value of
“0000”) to full-on (value of “1023”).
• Press EXIT, or press the flashing encoder
switch located below the scribble strip show-
ing another test mode to simultaneously dis-
engage the fader group test mode and enter
the newly selected mode. The encoder switch
LED for the new choice will light solid while
the other choices flash.
Touch Test Mode
Touch test mode places the faders in a test mode
where the scribble strips indicate when a fader
has been touched and at what frequency the
fader is currently recognizing.
When “Tch” Fader Test Mode is Engaged:
• The encoder switch LED located below the
scribble strip which shows “Tch” will light
solid indicating that this is the chosen test
mode.
• All other display test menu items shown on
the scribble strips as well as their associated
flashing encoder switch LEDs, will remain vis-
ible in this test mode. The scribble strip dis-
plays will toggle back and forth between the
fader touch values, as indicated below, which
allows you to select another display test mode
without the need to first “Exit” this mode.
•Touch any fader or group of faders to activate
the test.
• The fader frequency value will be shown in
the scribble strips using 3 characters and the
4th character will always read “k” for “kHz.”
These values will be updated in real-time as a
fader is touched.
• Press the flashing encoder switch located be-
low the scribble strip showing another test
mode to simultaneously disengage the fader
touch test mode and enter the newly selected
mode. The encoder switch LED for the new
choice will light solid while the other choices
flash.
• When finished, press EXIT.
To Next Page
Loading...
Need help?
General
