DigiDesign Control 24 User Manual

Control|24 Guide140
To access footswitch SW1 settings:
■ Press the flashing encoder switch below the
label “SW1.”
The text label “SW1” will be displayed on the far
right dual 4-character scribble strip display in
the CHANNEL BAR.
PlayStop is the default function choice and is
indicated by the solidly lit encoder switch LED
below this choice.
Footswitch 2 Page
This mode allows you to program the function-
ality of a SPST switch connected to the SW2 _”
jack located on the rear panel of Control|24.
The choices are Play/Stop, Record in/out, and re-
mote talkback. You can also change the polarity
of the switch closure.
To access footswitch SW1 settings:
■ Press the flashing encoder switch below the
label “SW2.”
The text label “SW2” will be displayed on the far
right dual 4-character scribble strip display in
the CHANNEL BAR.
Talkback is the default function choice and is in-
dicated by the solidly lit encoder switch LED be-
low this choice.
Sys Reset Page
The Sys Reset page allows you to reset Con-
trol|24 to the factory default settings.
To reset Control|24:
1 Press the UTILITY switch. The switch LED
flashes, indicating that a special mode has been
entered.
2 The text label “Util menu” will be displayed in
the dual 4-character scribble strip displays in the
CHANNEL BAR and the UTILITY menu items
are displayed on the channel scribble strips as
outlined above.
3 The label “Sys Reset” appears on channel
scribble strips 11 & 12. Press the flashing en-
coder switch below the choice to start the reset
process.
4 The label “Sys Reset” will be displayed in the
dual 4-character scribble strip in the CHANNEL
BAR.
5 Press the flashing encoder switch below the
scribble strip showing “Cncl” to cancel out of
the sys reset function. Following this action, the
menu will be returned one level up.
6 Press the flashing encoder switch below the
scribble strip showing “Ok” to reset Control|24
to the default factory settings.
7 Press the flashing encoder switch below the
scribble strip showing “Cncl” to cancel out of
the sys reset function. Following this action, the
menu will be returned one level up.

DigiDesign Control 24 Specifications

General

Channels	24
Faders	24 motorized 100mm faders
Connectivity	Ethernet
Compatibility	Pro Tools
Audio Interface	No built-in audio interface
EQ	4-band EQ per channel
MIDI I/O	Yes
Footswitch I/O	Yes
Power Supply	Internal