DigiDesign Control 24 User Manual

Control|24 Guide106
3 Press the SEND MUTE switch. Its LED will
light, indicating that you are in Send Mute
mode.
4 Press an encoder switch on a channel to mute
the selected send on that channel.
Pre/Post Fader Send Status
To set pre/post send status from the Fader
section:
1 Make sure playback is stopped.
2 Make sure Control|24 is not in channel AS-
SIGN mode (the ASSIGN switch LED should be
off).
3 Select a send by pressing a master SEND
switch (A/F–E/J).
4 Press the global PRE/POST switch.
5 Press a channel encoder switch to toggle the
send between pre- and post-fader. The encoder
switch LED will light when the send is pre-fader.
Shortcuts
To toggle a send between pre- and post-fader
status for all channels:
1 Make sure playback is stopped, and that Con-
trol|24 is not in channel ASSIGN mode (the AS-
SIGN switch LED should be off).
2 Select a send by pressing a master SEND
switch (A/F–E/J).
3 Press the global PRE/POST switch.
4 While pressing APPLY TO ALL CHANNELS or
OPT(ALT)/ALL, press any channel’s encoder
switch.
To toggle a send between pre- and post-fader
status for all selected channels:
1 Make sure playback is stopped, and that Con-
trol|24 is not in channel ASSIGN mode (the AS-
SIGN switch LED should be off).
2 Select a send by pressing a master SEND
switch (A/F–E/J).
3 Press the global PRE/POST switch.
4 While pressing APPLY TO ALL SELECTED
CHANNELS or SHIFT/ADD+OPT(ALT)/ALL,
press any channel’s encoder switch.
Using Flip Mode with Sends
The FLIP switch, located above the SEND A/F
switch, remaps send controls to the touch-sensi-
tive channel faders.
Send levels are adjusted and automated using
channel faders. For stereo sends, send pan is
controlled with the encoder knobs.
Send mute can be toggled and automated using
the channel MUTE switches.
The encoder switches on each channel function
in Send Flip mode as pre- or post-fader toggle
switches.
See also “Plug-In Flip Mode” on page 116.
To engage Flip mode:
■ Press the FLIP switch. The switch LED will
flash, indicating that a special mode has been
entered. “Send Flip” will appear in the Channel
Bar Display.
To exit Flip mode:
■ Press either the FLIP or the ESCAPE /CANCEL
switch. Both return Control|24 to the state it
was in prior to entering Flip mode.

DigiDesign Control 24 Specifications

General

Channels	24
Faders	24 motorized 100mm faders
Connectivity	Ethernet
Compatibility	Pro Tools
Audio Interface	No built-in audio interface
EQ	4-band EQ per channel
MIDI I/O	Yes
Footswitch I/O	Yes
Power Supply	Internal