DigiDesign Control 24 User Manual

Control|24 Guide46
Control and Audition Sections
Directly above the main Transport are the fol-
lowing special function Transport controls:
ONLINE Toggles the transport between online
and offline.When lit, the transport is online.
GO TO START Sets the playback cursor to the be-
ginning of the session.
GO TO END Sets the playback cursor to the end
of the session.
EXT TRANS Selects a single external transport
(device) as the Transport Master.
QUICK PUNCH Toggles QuickPunch recording
mode.
In addition to the above, there are several mod-
ifier shortcuts for transport functions:
• OPT(ALT)/ALL+PLAY: engages Pro Tools Pause
mode.
• SHIFT/ADD+PLAY: initiates half-speed play-
back.
• SHIFT/ADD+STOP: cancels the current record
pass.
•SHIFT/ADD+REWIND: returns to zero (RTZ).
• CTL/CLUTCH+RECORD: cycles through the
various record modes (normal, QuickPunch,
Loop).
• CTL/CLUTCH+PLAY: cycles through playback
modes.
• CTL/CLUTCH+EXT TRANS: cycles through
available machine master choices, (such as
Pro Tools, Serial Machine, and ADAT).
• OPT(ALT)/ALL+IN or OUT: centers the left or
right side of any current on-screen waveform
selection in the Edit Window.
• (CTRL)+IN or OUT: enter mode for pre-roll
and post-roll.
Audition Controls
The Audition controls include pre- and post-roll
settings and other playback options that are es-
pecially useful while auditioning selections, ed-
its, and fades.
LOOP PLAYBACK toggles Loop Playback on or
off (LED is lit when enabled).
LOOP RECORD toggles Loop Record on or off
(LED is lit when enabled).
AUDITION enables Audition mode, which deter-
mines the function of the PRE ROLL, IN, OUT
and POST ROLL switches. The AUDITION LED
lights in Audition mode.
PRE ROLL, IN, OUT and POST ROLL function dif-
ferently in each mode:
• In standard mode (AUDITION switch is off),
they activate pre/post roll and define playback
in/out points (IN and OUT).
• In Audition mode (AUDITION switch is lit)
these four switches each audition a unique
range of audio in and around the current Edit
selection.
Pre-Roll and Post-Roll
To toggle Pre- or Post-roll on or off:
1 Make sure AUDITION is off.
2 Press PRE ROLL or POST ROLL.
Control and Audition sections

DigiDesign Control 24 Specifications

General

Channels	24
Faders	24 motorized 100mm faders
Connectivity	Ethernet
Compatibility	Pro Tools
Audio Interface	No built-in audio interface
EQ	4-band EQ per channel
MIDI I/O	Yes
Footswitch I/O	Yes
Power Supply	Internal