C
HAPTER
34
| Loopback Detection Commands
– 1025 –
COMMAND USAGE
u When using vlan-based mode, loopback detection control frames are
untagged or tagged depending on the port’s VLAN membership type.
u When using vlan-based mode, ingress filtering for the port is enabled
automatically if not already enabled by the switchport ingress-filtering
command. The port’s original setting for ingress filtering will be
restored when loopback detection is disabled.
u When the loopback detection mode is changed, any ports placed in
shutdown state by the loopback detection process will be immediately
restored to operation regardless of the remaining recover time.
EXAMPLE
This example sets the loopback detection mode to VLAN based.
Console(config)#loopback-detection mode vlan-based
Console(config)#
loopback-detection
recover-time
This command specifies the interval to wait before the switch automatically
releases an interface from shutdown state. Use the no form to restore the
default setting.
SYNTAX
loopback-detection recover-time seconds
no loopback-detection recover-time
seconds - Recovery time from shutdown state.
(Range: 60-1,000,000 seconds, or 0 to disable automatic recovery)
DEFAULT SETTING
60 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
u When the loopback detection mode is changed, any ports placed in
shutdown state by the loopback detection process will be immediately
restored to operation regardless of the remaining recover time.
u If the recovery time is set to zero, all ports placed in shutdown state
can be restored to operation using the loopback-detection release
command. To restore a specific port, use the no shutdown command.
EXAMPLE
Console(config)#loopback-detection recover-time 120
Console(config-if)#
To Next Page