C
HAPTER
20
| Using the Command Line Interface
CLI Command Groups
– 691 –
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
Console#
CLI COMMAND GROUPS
The system commands can be broken down into the functional groups
shown below
.
Table 47: Command Group Index
Command Group Description Page
General Basic commands for entering privileged access mode,
restarting the system, or quitting the CLI
695
System Management Display and setting of system information, basic modes
of operation, maximum frame size, file management,
console port and telnet settings, system logs, SMTP
alerts, the system clock, and switch clustering
703
Simple Network
Management Protocol
Activates authentication failure traps; configures
community access strings, and trap receivers
773
Remote Monitoring Supports statistics, history, alarm and event groups 795
Flow sampling Used with a remote sFlow Collector to provide an
accurate, detailed and real-time overview of the types
and levels of traffic present on the network
803
User Authentication Configures user names and passwords, command
privilege levels, logon access using local or remote
authentication, management access through the web
server, Telnet server and Secure Shell; as well as port
security, IEEE 802.1X port access control, and restricted
access based on specified IP addresses
811
General Security
Measures
Segregates traffic for clients attached to common data
ports; and prevents unauthorized access by configuring
valid static or dynamic addresses, web authentication,
MAC address authentication, filtering DHCP requests and
replies, and discarding invalid ARP responses
875
Access Control List Provides filtering for IPv4 frames (based on address,
protocol, TCP/UDP port number or TCP control code),
IPv6 frames (based on address, DSCP traffic class, or
next header), or non-IP frames (based on MAC address
or Ethernet type)
937
Interface Configures the connection parameters for all Ethernet
ports, aggregated links, and VLANs
961
Link Aggregation Statically groups multiple ports into a single logical trunk;
configures Link Aggregation Control Protocol for port
trunks
981
Power over Ethernet Configures power output for connected devices 999
Mirror Port Mirrors data to another port for analysis without affecting
the data passing through or the performance of the
monitored port
995
Rate Limit Controls the maximum rate for traffic transmitted or
received on a port
1005
Automatic Traffic Control Configures bounding thresholds for broadcast and
multicast storms which can be used to trigger configured
rate limits or to shut down a port
1007
To Next Page
Loading...
