C
HAPTER
2
| Initial Switch Configuration
Connecting to the Switch
– 74 –
u Control port access through IEEE 802.1X security or static address
filtering
u Filter packets using Access Control Lists (ACLs)
u Configure up to 4093 IEEE 802.1Q VLANs
u Enable GVRP automatic VLAN registration
u Configure IP routing for unicast traffic
u Configure IGMP multicast filtering
u Upload and download system firmware or configuration files via HTTP
(using the web interface) or FTP/TFTP (using the command line or web
interface)
u Configure Spanning Tree parameters
u Configure Class of Service (CoS) priority queuing
u Configure static or LACP trunks (up to 16)
u Enable port mirroring
u Set storm control on any port for excessive broadcast, multicast, or
unknown unicast traffic
u Display system information and statistics
REQUIRED
CONNECTIONS
The switch provides an RS-232 serial port that enables a connection to a
PC or terminal for monitoring and configuring the switch. A null-modem
console cable is provided with the switch.
Attach a VT100-compatible terminal, or a PC running a terminal emulation
program to the switch. You can use the console cable provided with this
package, or use a null-modem cable that complies with the wiring
assignments shown in the Installation Guide.
To connect a terminal to the console port, complete the following steps:
1. Connect the console cable to the serial port on a terminal, or a PC
running terminal emulation software, and tighten the captive retaining
screws on the DB-9 connector.
2. Connect the other end of the cable to the RS-232 serial port on the
switch.
3. Make sure the terminal emulation software is set as follows:
n
Select the appropriate serial port (COM port 1 or COM port 2).
n
Set the baud rate to 115200 bps.
To Next Page
Loading...
