Digisol DG-GS4528SE - Displaying Hardware;Software Versions

C HAPTER 4 | Basic Management Tasks
Displaying Hardware/Software Versions
– 115 –
DISPLAYING HARDWARE/SOFTWARE VERSIONS
Use the System > Switch page to display hardware/firmware version
numbers for the main board and management software, as well as the
power status of the system.
CLI REFERENCES
u "System Management Commands" on page 703
PARAMETERS
The following parameters are displayed:
Main Board Information
u Serial Number – The serial number of the switch.
u Number of Ports – Number of built-in ports.
u Hardware Version – Hardware version of the main board.
u Main Power Status – Displays the status of the internal power supply.
u Redundant Power Status – Displays the status of the redundant
power supply.
Management Software Information
u Role – Shows that this switch is operating as Master or Slave.
u EPLD Version – Version number of EEPROM Programmable Logic
Device.
u Loader Version – Version number of loader code.
u Diagnostics Code Version – Version of Power-On Self-Test (POST)
and boot code.
u Operation Code Version – Version number of runtime code.
u Thermal Detector – The detector is near the back of the unit.
u Temperature – Temperature at specified thermal detection point.