C
HAPTER
22
| System Management Commands
Switch Clustering
– 769 –
EXAMPLE
Console(config)#cluster
Console(config)#
cluster commander This command enables the switch as a cluster Commander. Use the no
form to disable the switch as cluster Commander.
SYNTAX
[no] cluster commander
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
u Once a switch has been configured to be a cluster Commander, it
automatically discovers other cluster-enabled switches in the network.
These “Candidate” switches only become cluster Members when
manually selected by the administrator through the management
station.
u Cluster Member switches can be managed through a Telnet connection
to the Commander. From the Commander CLI prompt, use the
rcommand id command to connect to the Member switch.
EXAMPLE
Console(config)#cluster commander
Console(config)#
cluster ip-pool This command sets the cluster IP address pool. Use the no form to reset to
the default address.
SYNTAX
cluster ip-pool ip-address
no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to
cluster Members. The IP address must start 10.x.x.x.
DEFAULT SETTING
10.254.254.1
COMMAND MODE
Global Configuration
To Next Page