C
HAPTER
24
| Remote Monitoring Commands
– 799 –
show running-config command will display a message indicating that
this index is not available for the port to which is normally assigned.
For example, if control entry 15 is assigned to port 5 as shown below,
the show running-config command will indicate that this entry is not
available for port 8.
Console(config)#interface ethernet 1/5
Console(config-if)#rmon collection history controlEntry 15
Console(config-if)#end
Console#show running-config
!
interface ethernet 1/5
rmon collection history controlEntry 15 buckets 50 interval 1800
...
interface ethernet 1/8
no rmon collection history controlEntry 15
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#rmon collection history controlentry 21 owner mike buckets
24 interval 60
Console(config-if)#
rmon collection rmon1 This command enables the collection of statistics on a physical interface.
Use the no form to disable statistics collection.
SYNTAX
rmon collection rmon1 controlEntry index [owner name]
no rmon collection rmon1 controlEntry index
index – Index to this entry. (Range: 1-65535)
name – Name of the person who created this entry.
(Range: 1-127 characters)
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
u By default, each index number equates to a port on the switch, but can
be changed to any number not currently in use.
u If statistics collection is already enabled on an interface, the entry must
be deleted before any changes can be made with this command.
u The information collected for each entry includes:
input octets, packets, broadcast packets, multicast packets, undersize
packets, oversize packets, fragments, jabbers, CRC alignment errors,
collisions, drop events, and packets of specified lengths
To Next Page
Loading...
Need help?
General
