EasyManuals Logo

Digisol DG-GS4528SE User Manual

Digisol DG-GS4528SE
1416 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #908 background imageLoading...
Page #908 background image
C
HAPTER
27
| General Security Measures
ARP Inspection
– 922 –
show ip source-guard
binding
This command shows the source guard binding table.
SYNTAX
show ip source-guard binding [dhcp-snooping | static]
dhcp-snooping - Shows dynamic entries configured with DHCP
Snooping commands (see page 899)
static - Shows static entries configured with the ip source-guard
binding command (see page 918).
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show ip source-guard binding
MAC Address IP Address Lease(sec) Type VLAN Interface
----------------- --------------- ---------- -------------- --------- ---------
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#
ARP INSPECTION
ARP Inspection validates the MAC-to-IP address bindings in Address
Resolution Protocol (ARP) packets. It protects against ARP traffic with
invalid address bindings, which forms the basis for certain “man-in-the-
middle” attacks. This is accomplished by intercepting all ARP requests and
responses and verifying each of these packets before the local ARP cache is
updated or the packet is forwarded to the appropriate destination,
dropping any invalid ARP packets.
ARP Inspection determines the validity of an ARP packet based on valid IP-
to-MAC address bindings stored in a trusted database – the DHCP snooping
binding database. ARP Inspection can also validate ARP packets against
user-configured ARP access control lists (ACLs) for hosts with statically
configured IP addresses.
This section describes commands used to configure ARP Inspection.
Table 98: ARP Inspection Commands
Command Function Mode
ip arp inspection Enables ARP Inspection globally on the switch GC
ip arp inspection filter Specifies an ARP ACL to apply to one or more VLANs GC
ip arp inspection log-buffer
logs
Sets the maximum number of entries saved in a log
message, and the rate at these messages are sent
GC
ip arp inspection validate Specifies additional validation of address
components in an ARP packet
GC
ip arp inspection vlan Enables ARP Inspection for a specified VLAN or range
of VLANs
GC

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digisol DG-GS4528SE and is the answer not in the manual?

Digisol DG-GS4528SE Specifications

General IconGeneral
BrandDigisol
ModelDG-GS4528SE
CategorySwitch
LanguageEnglish

Related product manuals