C
HAPTER
19
| Unicast Routing
Configuring the Routing Information Protocol
– 669 –
3. Add the address of any static neighbors which may not readily to
discovered through RIP.
4. Click Apply.
Figure 414: Specifying a Static RIP Neighbor
To show static RIP neighbors:
1. Click Routing Protocol, RIP, Neighbor Address.
2. Select Show from the Action list.
Figure 415: Showing Static RIP Neighbors
CONFIGURING ROUTE
REDISTRIBUTION
Use the Routing Protocol > RIP > Redistribute (Add) page to import
external routing information from other routing domains (that is, directly
connected routes, protocols, or static routes) into this autonomous system.
CLI REFERENCES
u "redistribute" on page 1400
PARAMETERS
These parameters are displayed:
u Protocol – The type of routes that can be imported include:
n
Connected – Imports routes that are established automatically just
by enabling IP on an interface.
n
Static – Static routes will be imported into this routing domain.
n
OSPF – External routes will be imported from the Open Shortest
Path First protocol into this routing domain.
To Next Page
Loading...
