Digisol DG-GS4528SE - Notification Log Commands; Table 69: Show Snmp View - Display Description

C HAPTER 23 | SNMP Commands
Notification Log Commands
– 789 –
Notification Log Commands
nlm This command enables or disables the specified notification log.
SYNTAX
[no] nlm filter-name
filter-name - Notification log name. (Range: 1-32 characters)
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
COMMAND USAGE
u Notification logging is enabled by default, but will not start recording
information until a logging profile specified by the snmp-server notify-
filter command is enabled by the nlm command.
u Disabling logging with this command does not delete the entries stored
in the notification log.
EXAMPLE
This example enables the notification log A1.
Console(config)#nlm A1
Console(config)#
snmp-server notify-
filter
This command creates an SNMP notification log. Use the no form to
remove this log.
SYNTAX
[no] snmp-server notify-filter profile-name remote ip-address
profile-name - Notification log profile name. (Range: 1-32
characters)
Table 69: show snmp view - display description
Field Description
View Name Name of an SNMP view.
Subtree OID A branch in the MIB tree.
View Type Indicates if the view is included or excluded.
Storage Type The storage type for this entry.
Row Status The row status of this entry.