C
HAPTER
19
| Unicast Routing
Configuring the Routing Information Protocol
– 664 –
Figure 408: Configuring General Settings for RIP
CLEARING ENTRIES
FROM
THE ROUTING
TABLE
Use the Routing Protocol > RIP > General (Clear Route) page to clear
entries from the routing table based on route type or a specific network
address.
CLI REFERENCES
u "clear ip rip route" on page 1409
COMMAND USAGE
u Clearing “All” types deletes all routes in the RIP table. To avoid deleting
the entire RIP network, redistribute connected routes using the Routing
Protocol > RIP > Redistribute screen (page 669) to make the RIP
network a connected route. To delete the RIP routes learned from
neighbors, but keep the RIP network intact, clear “RIP” types from the
routing table.
PARAMETERS
These parameters are displayed:
u Clear Route By Type – Clears entries from the RIP routing table based
on the following types:
n
All – Deletes all entries from the routing table.
n
Connected – Deletes all currently connected entries.
n
RIP – Deletes all entries learned through the RIP.
n
Static – Deletes all static entries.
To Next Page