Digisol DG-GS4528SE - Figures

– 41 –
FIGURES
Figure 1: Home Page 94
Figure 2: Front Panel Indicators 95
Figure 3: System Information 114
Figure 4: General Switch Information 116
Figure 5: Configuring Support for Jumbo Frames 117
Figure 6: Displaying Bridge Extension Configuration 118
Figure 7: Copy Firmware 121
Figure 8: Saving the Running Configuration 122
Figure 9: Setting Start-Up Files 123
Figure 10: Displaying System Files 123
Figure 11: Configuring Automatic Code Upgrade 127
Figure 12: Manually Setting the System Clock 129
Figure 13: Setting the Polling Interval for SNTP 130
Figure 14: Configuring NTP 131
Figure 15: Specifying SNTP Time Servers 132
Figure 16: Adding an NTP Time Server 133
Figure 17: Showing the NTP Time Server List 133
Figure 18: Adding an NTP Authentication Key 134
Figure 19: Showing the NTP Authentication Key List 134
Figure 20: Setting the Time Zone 135
Figure 21: Console Port Settings 137
Figure 22: Telnet Connection Settings 139
Figure 23: Displaying CPU Utilization 140
Figure 24: Displaying Memory Utilization 141
Figure 25: Restarting the Switch (Immediately) 143
Figure 26: Restarting the Switch (In) 143
Figure 27: Restarting the Switch (At) 144
Figure 28: Restarting the Switch (Regularly) 144
Figure 29: Configuring Connections by Port List 148
Figure 30: Configuring Connections by Port Range 149
Figure 31: Displaying Port Information 150