C
HAPTER
19
| Unicast Routing
Configuring the Routing Information Protocol
– 677 –
DISPLAYING RIP
INTERFACE SETTINGS
Use the Routing Protocol > RIP > Statistics (Show Interface Information)
page to display information about RIP interface configuration settings.
CLI REFERENCES
u "show ip rip" on page 1410
PARAMETERS
These parameters are displayed:
u Interface – Source IP address of RIP router interface.
u Auth Type – The type of authentication used for exchanging RIPv2
protocol messages.
u Send Version – The RIP version to sent on this interface.
u Receive Version – The RIP version accepted on this interface.
u Rcv Bad Packets – Number of bad RIP packets received.
u Rcv Bad Routes – Number of bad routes received.
u Send Updates – Number of route changes.
WEB INTERFACE
To display RIP interface configuration settings:
1. Click Routing Protocol, RIP, Statistics.
2. Select Show Interface Information from the Action list.
Figure 422: Showing RIP Interface Settings
DISPLAYING PEER
ROUTER
INFORMATION
Use the Routing Protocol > RIP > Statistics (Show Peer Information) page
to display information on neighboring RIP routers.
CLI REFERENCES
u "show ip protocols rip" on page 1410
PARAMETERS
These parameters are displayed:
u Peer Address – IP address of a neighboring RIP router.
To Next Page