C
HAPTER
4
| Basic Management Tasks
Setting the System Clock
– 129 –
Figure 12: Manually Setting the System Clock
SETTING THE SNTP
POLLING INTERVAL
Use the System > Time (Configure General - SNTP) page to set the polling
interval at which the switch will query the specified time servers.
CLI REFERENCES
u "Time" on page 755
PARAMETERS
The following parameters are displayed:
u Current Time – Shows the current time set on the switch.
u SNTP Polling Interval – Sets the interval between sending requests
for a time update from a time server. (Range: 16-16384 seconds;
Default: 16 seconds)
WEB INTERFACE
To set the polling interval for SNTP:
1. Click System, then Time.
2. Select Configure General from the Step list.
3. Select SNTP from the Maintain Type list.
4. Modify the polling interval if required.
5. Click Apply
To Next Page
Loading...
