Digisol DG-GS4528SE - Table 97: IP Source Guard Commands

C HAPTER 27 | General Security Measures
IP Source Guard
– 917 –
show ipv6 dhcp
snooping statistics
This command shows statistics for DHCPv6 snooping client, server and
relay packets.
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show ipv6 dhcp snooping statistics
DHCPv6 Snooping Statistics:
Client Packet: Solicit, Request, Confirm, Renew, Rebind,
Decline, Release, Information-request
Server Packet: Advertise, Reply, Reconfigure
Relay Packet: Relay-forward, Relay-reply
State Client Server Relay Total
-------- -------- -------- -------- --------
Received 10 9 0 19
Sent 9 9 0 18
Droped 1 0 0 1
Console#
IP SOURCE GUARD
IP Source Guard is a security feature that filters IP traffic on network
interfaces based on manually configured entries in the IP Source Guard
table, or dynamic entries in the DHCP Snooping table when enabled (see
"DHCPv4 Snooping" on page 899). IP source guard can be used to prevent
traffic attacks caused when a host tries to use the IP address of a neighbor
to access the network. This section describes commands used to configure
IP Source Guard.
Table 97: IP Source Guard Commands
Command Function Mode
ip source-guard binding Adds a static address to the source-guard binding
table
GC
ip source-guard Configures the switch to filter inbound traffic based
on source IP address, or source IP address and
corresponding MAC address
IC
ip source-guard max-
binding
Sets the maximum number of entries that can be
bound to an interface
IC
show ip source-guard Shows whether source guard is enabled or disabled
on each interface
PE
show ip source-guard
binding
Shows the source guard binding table PE