C
HAPTER
20
| Using the Command Line Interface
CLI Command Groups
– 692 –
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
Loopback Detection Detects general loopback conditions caused by hardware
problems or faulty protocol settings
1023
UniDirectional Link
Detection
Detect and disables unidirectional links 1029
Address Table Configures the address table for filtering specified
addresses, displays current entries, clears the table, or
sets the aging time
1035
Spanning Tree Configures Spanning Tree settings for the switch 1041
ERPS Configures Ethernet Ring Protection Switching for
increased availability of Ethernet rings commonly used in
service provider networks
1069
VLANs Configures VLAN settings, and defines port membership
for VLAN groups; also enables or configures private
VLANs, protocol VLANs, voice VLANs, and QinQ tunneling
1101
Class of Service Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for DSCP
1149
Quality of Service Configures Differentiated Services 1163
Multicast Filtering Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a multicast
router; also configures multicast VLAN registration
1183
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
1251
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
1277
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and
maintain the links to subscriber CPEs
1319
Domain Name Service Configures DNS services. 1329
Dynamic Host
Configuration Protocol
Configures DHCP client and relay functions 1339
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
1349
IP Routing Configures static and dynamic unicast routing 1389
Table 47: Command Group Index (Continued)
Command Group Description Page
To Next Page