C
HAPTER
6
| VLAN Configuration
Protocol VLANs
– 212 –
u VLAN ID – VLAN to which matching protocol traffic is forwarded.
(Range: 1-4093)
u Priority – The priority assigned to untagged ingress traffic.
(Range: 0-7, where 7 is the highest priority)
WEB INTERFACE
To map a protocol group to a VLAN for a port or trunk:
1. Click VLAN, Protocol.
2. Select Configure Interface from the Step list.
3. Select Add from the Action list.
4. Select a port or trunk.
5. Enter the identifier for a protocol group.
6. Enter the corresponding VLAN to which the protocol traffic will be
forwarded.
7. Set the priority to assign to untagged ingress frames.
8. Click Apply.
Figure 84: Assigning Interfaces to Protocol VLANs
To show the protocol groups mapped to a port or trunk:
1. Click VLAN, Protocol.
2. Select Configure Interface from the Step list.
3. Select Show from the Action list.
4. Select a port or trunk.
To Next Page